How to Unlock Auto Battles in Jujutsu Kaisen Phantom Parade

Jujutsu Kaisen Phantom Parade is a turn-based RPG gacha that takes a lot of time to progress. This is partly due to the battle system combined with the grindy nature of the progression system. You’ll play missions, hit a brick wall, repeat lower missions to get stronger, and repeat. However, there’s a way to let the game auto-battle for you, and it is also seen in the upper-right corner of the battle. You are probably here because it is disabled, and here’s how to unlock the auto-battle feature, including the sweep system in Jujutsu Kaisen Phantom Parade.

How to Turn On Auto Battles in Jujutsu Kaisen Phantom Parade

To unlock auto battles, you must reach episode 5 of the 1st chapter in the main story quest. It takes around 15 minutes or even faster if you skip through all the dialogue and cutscenes. After finishing episode 5, you’ll see the “Auto” button turn yellow on the upper-right corner of your screen when battling. Tap on it and make sure it is yellow and not grayed out.

Once you have it turned auto, you don’t have to set it again for the next missions you play. Every match or mission will now be on auto-battle until turned off.

When your characters fight automatically, they’ll use their best attacks and aim for the weakest enemy. Once they have their ultimate skills ready, they’ll use them immediately. Apart from auto-battling missions, you can also do a “sweep” which is better than an auto-battle because you can literally finish the mission instantly.

Related: How to Reroll in Jujutsu Kaisen Phantom Parade

How to Sweep Missions in Jujutsu Kaisen Phantom Parade

To unlock sweeps, you must complete the three clearance rating conditions on the specific mission. All of these conditions basically just mean that you need to finish the mission or quest without losing a single character. If you lose one character, you only get two conditions or two stars.

Once you get three stars, you’ll see the sweep option when choosing the mission again, as seen in the image above. You can change the number to how many runs you would like to automatically finish or sweep by tapping the “+” button. As long as you have enough AP, there’s no limit to it.